Elektronika kljuca
-
- Poruka: 2148
- Član foruma od: utorak, 13. okt. 2009. u 12:24h
- Lokacija: beograd-jajinci
Elektronika kljuca
Drugaru na mondeu crkla elektronika kljuca,ubacim mu stampanu plocicu iz drugog daljinca,prebacim njegovu ampulu sa kodom I njegov narezan mac,I centralno zakljucavanje ne radi,jel treba da se upari ta nova elektronika sa GEM- om ili kompom,ili kako vec???
- shomicus
- Poruka: 677
- Član foruma od: subota, 20. dec. 2008. u 19:03h
- Lokacija: Bgd,Vozdovac
Re: Elektronika kljuca
Ima procedura posle zamene baterije za ponovno setovanje.Koji je mondeo u pitanju,mk2 ili mk3 tj. da li ima dva ili tri dugmeta na daljinskom ključu?
-
- Poruka: 2148
- Član foruma od: utorak, 13. okt. 2009. u 12:24h
- Lokacija: beograd-jajinci
Re: Elektronika kljuca
Dvojka,isti je kljuc kao na fokusu I mondeu mk3,otprilike sam saznao probacemo veceras, ll pa l 3sec,ll pa l 3sec,ll pa l 3sec pa se vrati na 0 pa se stisne otkljucavanje na daljincu...
- shomicus
- Poruka: 677
- Član foruma od: subota, 20. dec. 2008. u 19:03h
- Lokacija: Bgd,Vozdovac
Re: Elektronika kljuca
Radio Frequency Programming Instructions:
Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
Wait until learn mode times out (20 seconds) or switch the ignition back to ON.
Evo ako može da pomogne ;-)
Insert the ignition key and turn from position II (Ignition) to position 0 (All off) and back four times within three seconds.
Remove the ignition key. The locking control system is now in "learn mode" for the next 20 seconds and the red warning system LED (By the clock) stays on continuously to indicate this.
During the 20 seconds press one of the transmitter buttons. The remotes signal and code number is learned by the locking module and is indicated by flashing the warning system LED.
Wait until learn mode times out (20 seconds) or switch the ignition back to ON.
Evo ako može da pomogne ;-)
-
- Poruka: 2148
- Član foruma od: utorak, 13. okt. 2009. u 12:24h
- Lokacija: beograd-jajinci
Re: Elektronika kljuca
Ovde sam video proceduru,http://www.freefordradiocode.co.uk/fordkey.html
malo se razlikuje od tvoje...
malo se razlikuje od tvoje...